This is my eleventh video. It was the first Kung Fu Maintenance video I used my voice on. To my surprise it has gotten far more hits than any of my others. This is true even though (among my vids) it is one of the most disliked uploaded videos. Perhaps for the noise (voice) (music) but I think more than anything for the fact that this repair takes so much patience. It is a tried and true method and I have done it many times. It is not my favorite repair either but it normally works, unless the fan is beyond balancing. I have had many dislikes over the brand of this particular fan. Also I think it gets many dislikes because there are some who think it is not worth it to balance a fan (or believe it impossible) and would rather buy a new one. This is fine. (You can make pizza, if you have the dough( and sauce, and cheese etc. . ). What follows is for the savers.
First clean the fan. Then tighten up all the screws. Tighten the fan blade screws and especially the down rod set screws where the down rod goes into the fan top. Often times this is enough to fix the wobble. Sometimes you can adjust the position of the light kit or the position of the down rod socket by pushing the whole fan up and turning a little bit (with power off of course). Try several different positions to see if you can rid the wobble.
If those attempts don’t rid your wobble than you will need a fan balancing kit. They are sold at most hardware stores or you can order one from my store Kung Fu Maintenance Supply and Appliance. They usually have instructions to follow which normally involve the following.
Clip the fan blade weight clip to the back edge of a fan blade either on the very end center or in the middle at the back of the blade. Turn the fan on and note if it wobbles more or less. Note the blade you started with than do the same on each of the other fan blades to determine which one gives you the least amount of wobble. This takes a lot of patience as you have to let the fan blades stop each time so no one gets hurt.
Next clip the fan weight in the center at the back of the fan blade with the least wobble. Slide the clip two inches toward the fan center and check the wobble. Than slide the clip four inch away from the center of the fan blade. Whichever direction towards the center or further away gives you the least wobble continue checking for the least wobble in two inch increments until you determine the best spot for least wobble. This is where you will stick one of the fan weights clean the spot on the center top of the fan blade really well. This way the weight doesn’t go flying off later (It’s all fun and games till someone gets hurt). Remove the plastic covering the adhesive and press it down top center of the fan blade directly in line with your fan weight clip.
Now you can remove the fan weight clip and check for wobbling. All set you’re all done but if there is still some wobble sometimes it takes more than one weight. This is why the weight kit usually comes with two or three weights. Repeat the entire process again with the second and if necessary the third weight. Yes it is understandable that this video gets some dislikes. I could even sometimes dislike it myself. It puts a real tester on caffeinated people and folks with ADD.
~~~Increasing your Balance~~~
~~~~~~~~~~Kung Fu Maintenance~~~~~~~~~~~
