noisy

Five Most Common Problems With Refrigerators ~ Blog

Ok, today I am going to be discussing with you the five most common problems with refrigerators.

0:18 Number one is a stuck fridge fan. When you open your fridge and it is in it’s run cycle you should hear the sound like you are hearing now, the fan motor spinning. Sometimes what happens is the fan blades get stuck against the side or the fan blade itself goes so far back that it seats against the motor and than the blades get stuck and don’t turn.

0:42 Second most common problems with refrigerators is drips from the ceiling. Now if it’s just small drips it can be caused by food put in that’s hot like boiling or something that had boiled and than set in the fridge without a cover on it. The way to eliminate that is to keep a cover on your food.

But if your seeing excessive drips from the inside center here then it may indicate that you have a clogged condensate drain which is a very common problem with refrigerators.

01:11 The third most common problem with refrigerators is the compressor not running. If you listen back here you can kind of hear the hum of the compressor. So if you don’t hear that sound that low humming sound that’s different from the fan going than your starter may need to be replaced on the compressor.

01:31 The fourth most common problem with refrigerators is torn gaskets. The way that you prevent that from happening is to clean the gaskets here often, and to clean the fridge surface here often, where it mates. What happens is sticky foods stick in there and than pulling apart from the gasket
eventually can tear the gasket wear out the gasket so that’s the way to
kind of prevent it.

Each door manufacturer is different so you might have to consult your directions on how to replace your gasket. Some of them will have screws along the inside portion here of the gasket in order to change it.
Others will have a press in place groove that the gasket gets pressed into.
Others the entire door portion will pull apart so that you can replace the gasket. So each kind is just slightly different.

02:20 And the fifth most common problem with refrigerators is being off balance. What you want is for when you let your fridge door go you want it to just close nice and gently and close all the way.

You want the fridge to aim towards the back just a tiny bit so that condensate goes down and stays along the back of the fridge and settles into the pan that’s on the back on the top of the compressor usually. But anyway, you want your fridge to angle towards the back just a tiny bit.

If your fridge is off balance there is usually an adjustment screw here.
Or some fridges have a wheel that is turned here. This ones got a wheel that’s turned, as you can see, one on each side. And these can be adjusted
just by lifting up a little bit on the fridge and than turning this either by hand or with channel locks.

So that’s the five most common problems with refrigerators.

Posted by Kung Fu Maintenance in The KFM Blog, Tips, 0 comments

Washing Machine: Five Most Common Problems Blog

Washing Machine: Five Most Common Problems Blog

OK, today I wanted to go over the five most common problems with washing machines with you.

00:19 The number one most often problem with washing machines is a washing machine that doesn’t drain or spin, most often caused by a broken lid switch.

You should hear a click as this goes into place. If you don’t hear that click then your, or if your washing machine is not going into its final cycles
it’s most often this lid switch here.

Sometimes you can just press on this right side and get it to engage the switch. Also occasionally you can just adjust the post a little bit
so that the post will stick further into the switch which will engage the switch. Also sometimes you can just adjust the switch or tighten it up.
Often it needs to be replaced I have a video on that.

01:05 Second most often problem with washing machines often goes undetected something you’d probably want to check regularly is that your agitator dogs are working properly. What it should do is turn the bottom one-way or the other. So this one is turning it like it should and the agitator dogs are functioning. Now if it’s not doing that than your clothes are just getting rinsed. They are not really getting washed. It is an often missed
problem with washing machines. And it is probably very common because the agitator dogs inside here are designed to break if someone’s arm was to get stuck in here or if something was to bind up too much the agitator dogs will actually strip on purpose as a safety mechanism.

01:50 Third most common problem with washing machines is a clogged pump at the impeller. Sometimes a penny or a button, or something else, a bobby pin, whatever goes down the drain line and gets stuck at the pump.

02:05 Fourth most common problem is a leak. Most often leaks occur up on the left side.

Fifth most common problem is a washing machine out of balance. Now the most often cause of the machine being out of balance is just a matter of redistributing the clothes. Usually a towel or something gets on one side and you hear the whump whump whump whump of the machine.

What you need to do is open the lid and than go ahead and readjust the clothing or go ahead and readjust the towel. Readjust the items in the bin to get it more balanced. Then go ahead and run it again see if it works out and you have no more out of balance deal.

Sometimes you could lose a spring. Most often times it’s just that the
machine is out of balance. Eventually I’ll have to make you a video showing you how to reset the spring if it did come off.

There are three different shocks and then there is a spring that holds the machine basin in place.

Now the way to check if your machine is still in balance is just ahead and run it empty with water. Let the water fill up. If the machine finds its balance than you know it was just a matter of the clothes or the laundry items being out of balance

Anyway that is the five most common problems with washing machines!

~ TFW ~..~ KFM ~

Posted by Kung Fu Maintenance in The KFM Blog, Tips, 0 comments